Guide: How to Remove the Front Engine Hood Water Strip on Xiaomi SU7 Pure Electric Car
Introduction
In the realm of electric vehicles (EVs), maintaining components like the front engine hood water strip is essential for optimal performance and longevity. For Xiaomi SU7, an exemplary pure electric car, here's a comprehensive guide on how to remove the front engine hood water strip.
Step-by-Step Guide

Preparation:
Park the Xiaomi SU7 on a level surface and engage the parking brake.

Ensure the vehicle is turned off and the engine is cool to the touch.

Locate the Water Strip:

The front engine hood water strip is situated along the edge of the hood, providing a seal to prevent water from entering the engine compartment.

Gather Tools:

Before proceeding, gather the necessary tools:

Flathead screwdriver
Trim removal tool (optional)

Open the Hood:

Pop the hood of the Xiaomi SU7 by pulling the hood release lever located inside the cabin, usually below the dashboard on the driver's side.

Lift the hood and secure it using the hood support rod.

Access the Water Strip:

Inspect the edge of the front engine hood to locate the water strip.

Remove Fasteners:

Using a flathead screwdriver or trim removal tool, carefully pry out the fasteners securing the water strip in place.

Work systematically along the edge, starting from one end and moving towards the other.

Detach the Water Strip:

Once the fasteners are removed, gently pull the water strip away from the hood.

Take care not to damage the surrounding paint or trim.

Inspect and Clean:

With the water strip removed, inspect it for any signs of damage or wear.

Clean the surface of the hood where the water strip was attached to remove any dirt or debris.

Installation of New Water Strip (if necessary):

If the water strip is damaged or worn, replace it with a new one.
Align the new water strip along the edge of the hood and press firmly to secure it in place.

Reattach the fasteners to ensure a snug fit.

Final Checks:

Close the hood of the Xiaomi SU7 and ensure it latches securely.
Test the closure to verify that the water strip is properly installed and functioning.

Conclusion
By following these steps, you can effectively remove and replace the front engine hood water strip on your Xiaomi SU7 pure electric car. Regular maintenance of components like the water strip ensures optimal performance and longevity, contributing to a seamless driving experience in this innovative electric vehicle.
Remember to always exercise caution when working with vehicle components and consult the owner's manual for specific instructions tailored to your Xiaomi SU7 model.